2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1451/51 Compressor Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007

DESCRIPTION

In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression.
DTC No.
DTC Detection Condition
Trouble Area
B1451/51
Open or short in solenoid of externally changeable compressor circuit
  1. A/C compressor*
  2. Harness and connector between air conditioning amplifier and A/C compressor*
  3. Air conditioning amplifier

HINT:
*: Compressor and pulley for except 2GR-FE, compressor and magnetic clutch for 2GR-FE


WIRING DIAGRAM

E115016E07

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (REG CTRL CURRNT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.

  1. Select the items below in the DATA LIST, and read the value displayed on the intelligent tester.

    Air conditioning amplifier:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Regulator Control Current
    Regulator control current /
    Min.: 0 A
    Max.: 0.997 A
    Value changes between 0 A and 0.997 A in accordance with A/C compressor operation
    -

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2. INSPECT A/C COMPRESSOR
E115015E06
  1. Disconnect the A/C compressor clutch connector.

  1. Measure the resistance of the connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SOL-) - 2 (SOL+)
    25°C (77°F)
    10.1 to 11.1 Ω



NG
REPLACE A/C COMPRESSOR
OK


3. CHECK WIRE HARNESS (A/C COMPRESSOR - AIR CONDITIONING AMPLIFIER)

  1. E115955E06
    Disconnect the B23 or B40 A/C compressor connector.

  1. Disconnect the E41 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B23-2 (SOL+) - E41-2 (SOL+)(*1)
    Below 1 Ω
    B23-2 (SOL+) - Body ground(*1)
    1 MΩ or higher
    B40-2 (SOL+) - E41-2 (SOL+)(*2)
    Below 1 Ω
    B40-2 (SOL+) - Body ground(*2)
    1 MΩ or higher

    *1: for Except 2AD-FTV, 2AD-FHV*2: for 2AD-FTV, 2AD-FHV



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK WIRE HARNESS (A/C COMPRESSOR - BODY GROUND)

  1. E119774E12
    Disconnect the B23 or B40 A/C compressor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    B23-1 (SOL-) - Body ground(*1)
    Below 1 Ω
    B40-1 (SOL-) - Body ground(*2)
    Below 1 Ω

    *1: for Except 2AD-FTV, 2AD-FHV*2: for 2AD-FTV, 2AD-FHV



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← B1451/51 Compressor Solenoid Circuit (Nov 2005 – Jul 2007)B1497/97 BUS IC Communication Malfunction (from Nov 2005) →