ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| INSPECT RELAY |
Disconnect the IG, IF and IQ junction block connectors.
Measure the resistance of the Defogger relay.


- Standard resistance:
Tester Connection
Specified Condition
1G-1 - 1F-2
10 kΩ or higher
1G-1 - 1F-2
Below 1 Ω
(when battery voltage is applied to terminals 1Q-12 and IQ-4)
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
