2005-2008 RAV4 · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT CLUTCH DISC ASSEMBLY

C127503
  1. Using a vernier caliper, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)

    If the depth is less than the minimum, replace the clutch disc assembly.

  1. Install the disc on the transaxle.

    NOTICE:
    Take care not to insert the clutch disc in the wrong direction.

  1. C127504E02
    Using a dial gauge, measure the disc runout.

    Maximum runout:
    0.8 mm (0.031 in.)

    If the runout is greater than the maximum, replace the clutch disc assembly.


INSPECT CLUTCH COVER ASSEMBLY

C127505E01
  1. Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

    Maximum wear:
    Measurement
    Maximum Wear
    A (Depth)
    0.5 mm (0.020 in.)
    B (Width)
    6.0 mm (0.236 in.)

    If the wear is greater than the maximum, replace the clutch cover assembly.


INSPECT FLYWHEEL SUB-ASSEMBLY

C127506
  1. Using a dial gauge, measure the flywheel runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    If the runout is greater than the maximum, replace the flywheel sub-assembly.


INSPECT CLUTCH RELEASE BEARING ASSEMBLY

C127507
  1. Check that the bearing moves smoothly without abnormal resistance by turning the sliding parts of the bearing (contact surfaces with the clutch cover) while applying force in the axial direction.

  1. Inspect the bearing for damage or wear.
    If necessary, replace the release bearing assembly.

← REMOVAL (from Aug 2007)INSTALLATION (Nov 2005 – Dec 2006) →