REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- NOTICE:
- The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
- Make sure foreign matter does not attach to the master cylinder's piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
- The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
| 1. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE, 2AZ-FE) |
Remove the air cleaner case (Click here).
- HINT:
- Refer to the procedures from the removal of the purge VSV up until the removal of the air cleaner case.
| 2. REMOVE AIR CLEANER BRACKET (for 2AD-FTV, 2AD-FHV) |
Remove the air cleaner bracket (Click here).
- HINT:
- Refer to the procedures from the removal of the air cleaner cap sub-assembly up until the removal of the air cleaner bracket.
| 3. DRAIN BRAKE FLUID |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() ![]() |
Release the vacuum pressure in the brake booster as follows.
Stop the engine.
Depress the brake pedal several times.
for Manual Transaxle:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using SST, disconnect the 2 brake lines labeled C from the master cylinder.
- SST
- 09023-00101
Remove the 2 nuts.

Pull out the master cylinder from the brake booster.
- NOTICE:
- The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
- Make sure foreign matter does not attach to the master cylinder's piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
- The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
Remove the O-ring from the master cylinder.

