2005-2008 RAV4 · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK BRAKE FLUID LEVEL WARNING SWITCH
  1. Remove the reservoir filler cap and strainer.

  1. Disconnect the brake fluid level warning switch connector.

  1. C129064E01
    Measure the resistance of the switch.

    HINT:
    There is a float inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Float up (Switch OFF)
    10 kΩ or higher
    1 - 2
    Float down (Switch ON)
    Below 1 Ω

    If the value is not as specified, replace the brake master cylinder reservoir sub-assembly.

  1. Add brake fluid to the MAX level.

← COMPONENTS (from Nov 2005)REMOVAL (Nov 2005 – Dec 2006) →