DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1.
REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
 |
Remove the claw and room light bracket.
- Remove the 2 bolts and drive gear.
| 2.
REMOVE SLIDING ROOF DRAIN HOSE JOINT LH |
 |
Remove the screw and joint.
| 3.
REMOVE SLIDING ROOF DRAIN HOSE JOINT RH |
 |
- HINT:
- Use the same procedures described for the LH side.
| 4.
REMOVE SUNSHADE TRIM SUB-ASSEMBLY |
 |
Slide and remove the sunshade trim.
| 5.
REMOVE SLIDING ROOF DRIVE CABLE |
 |
- NOTICE:
- Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.
Remove the 2 screws and 2 sliding roof side stoppers.
- Using a screwdriver, detach the 2 claws. Then slide the drip channel rearward to remove it.
- HINT:
- Tape the screwdriver tip before use.
- Using a screwdriver, slide the drive cables backward and remove them.
- HINT:
- Tape the screwdriver tip before use.