2005-2008 RAV4 · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL SLIDING ROOF DRIVE CABLE

B122192
  1. Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them.

    HINT:
    Tape the screwdriver tip before use.

  1. B131978
    Engage the 2 claws and install the sliding roof drip channel.

  1. B125928
    Install the 2 sliding roof side stoppers with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


2. ADJUST FULLY CLOSED POSITION

B084654E02
  1. Using a screwdriver, slide the sliding roof drive cable LH and RH to align the matchmarks.

    HINT:
    Tape the screwdriver tip before use.


3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

B133638E01
  1. Insert the sunshade trim into the sliding roof housing.


4. INSTALL SLIDING ROOF DRAIN HOSE JOINT LH

B129369
  1. Install the joint with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


5. INSTALL SLIDING ROOF DRAIN HOSE JOINT RH

HINT:
Use the same procedures described for the LH side.


6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

B125922
  1. Install the drive gear with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. B125921
    Attach the claw and install the sliding roof drive gear bracket.

← DISASSEMBLY (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →