2005-2008 RAV4 · Service Manual BRAKE

VSC Warning Light Remains ON

Circuit diagnosis · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008

DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN communication system.
w/o Multi-information display:
If the skid control ECU stores any DTCs which relate to the VSC system, the VSC warning light comes on in the combination meter.
w/ Multi-information display:
If the skid control ECU stores any DTCs which relate to the VSC system, the master caution indicator light comes on and the warning message is displayed on the multi information display in the combination meter.

WIRING DIAGRAM

C130878E01
C136073E01

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



NG
REPAIR CAN COMMUNICATION SYSTEM
OK


2. INSPECT SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. CHECK COMBINATION METER
  1. Check the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← VSC Warning Light Remains ON (Jan 2007 – Jul 2007)VSC Warning Light does not Come ON (Nov 2005 – Dec 2006) →