2005-2008 RAV4 · Service Manual BODY

B2313 Glass Position Initialization Incomplete

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The driver door power window regulator motor is driven by operating the power window regulator master switch. The driver door power window regulator motor has motor, regulator, and ECU functions.
When the ECU determines that the driver door power window regulator motor assembly has not been initialized, DTC B2313 is set.

NOTICE:
  1. The power window control system uses a multiplex communication system (LIN). Inspect the communication function by following HOW TO PROCEED WITH TROUBLESHOOTING. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
  2. When the power window regulator motor assembly (on the driver side) is reinstalled or replaced, the power window control system must be initialized.
  3. After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
    1. Close the power window by fully pulling up the power window switch and holding it in the AUTO UP position.
    2. Open the power window by fully pushing down the switch.

DTC No.
DTC Detection Condition
Trouble Area
B2313
  1. Power window regulator motor (on driver side) not initialized
  2. Power window regulator motor (on driver side) malfunctions
  1. Power window regulator motor (on driver side)
  2. Power window regulator motor (on driver side) not initialized

INSPECTION PROCEDURE

NOTICE:
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn the courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.


1. CHECK DTC OUTPUT
  1. Turn the ignition switch on (IG) and initialize the power window regulator motor (on the driver side) (Click here).

  1. Turn the ignition switch off.

  1. Wait for at least 10 seconds, and then turn the ignition switch on (IG).

  1. Check whether the DTC output recurs.

    Result 
    Display (DTC Output)
    Proceed to
    B2313
    A
    No output
    B



B
END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)
A

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)


← B2312 Driver Side Door Master Switch Malfunction (from Nov 2005)B2321 Driver Side Door ECU Communication Stop (from Nov 2005) →