B2321 Driver Side Door ECU Communication Stop
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
DTC B2321 is output when the communication between the power window regulator motor (driver side) and main body ECU stops for more than 10 seconds.- NOTICE:
- When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2321 |
No communication from power window regulator motor (driver side) for more than 10 seconds |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS (DTC B2321) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Select the following menu items: Body / Body ECU / DTC.
Result DTCs.
Result Display (DTC Output)
Proceed to
B2321
A
No DTC output
B
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (COMMUNICATION D DOOR MOTOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Body ECU / Data List / Comm D-Door Mtr.
Read the result displayed on the tester.
Item
Measurement Item / Display (Range)
Normal Condition
Communication D-Door Motor
Connection status between power window regulator motor assembly (driver door) and main body ECU /
OK or Stop
OK: Connection
Stop: No connection
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS (MAIN BODY ECU - REGULATOR MOTOR) |
Disconnect the H4*1 or G9*2 motor connector.

Disconnect the E18 junction block connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
- for LHD:
Tester Connection
Specified Condition
H4-9 (LIN) - E18-23 (LIN2)
Below 1 Ω
H4-9 (LIN) or E18-23 (LIN2) - Body ground
10 kΩ or higher
- for RHD:
Tester Connection
Specified Condition
G9-9 (LIN) - E18-23 (LIN2)
Below 1 Ω
G9-9 (LIN) or E18-23 (LIN2) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK WHETHER DTC OUTPUT RECURS (DTC B2321) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Check whether DTC B2321 recurs 10 seconds or more after the ignition switch is turned on (IG).
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
