2005-2008 RAV4 · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL

2. DISCONNECT REAR DISC BRAKE CYLINDER MOUNTING LH

  1. C127287
    Remove the 2 bolts and cylinder mounting.


3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the shoe adjusting hole plug from the rear disc.


4. REMOVE REAR DISC

  1. C129072E01
    Put matchmarks on the disc and axle hub.

  1. Release the parking brake.

  1. C127304
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the disc.


5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side)

  1. C127312
    Using needle-nose pliers, remove the 2 shoe return tension springs.


6. REMOVE PARKING BRAKE SHOE STRUT LH

7. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side)
  1. Using needle-nose pliers, remove the tension spring.


8. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
  1. Remove the screw set.


9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

  1. C127305
    Press the shoe hold-down spring to remove the pin, shoe hold-down spring and shoe.


10. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

  1. C127306
    Slide the shoe to remove the shoe hold-down spring, pin and shoe.

  1. Disconnect the parking brake cable from the parking brake shoe lever.


11. REMOVE PARKING BRAKE SHOE LEVER LH
← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →