B2799 Engine Immobiliser System Malfunction
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the ID code box; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the ID code box and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no certification ECU DTCs are present. If present, troubleshoot the certification ECU DTCs first.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2799 |
One of following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Delete the DTC (Click here).
Recheck for the DTC.
- OK:
- B2799 output does not reoccur.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (ID CODE BOX - ECM) |


Disconnect the E51 box connector.
Disconnect the A12 ECM connector.
Measure the resistance of the wire harness connectors.
- Standard resistance:
- for 1AZ-FE:
Tester Connection
Specified Condition
E51-5 (EFII) - A12-10 (IMO)
Below 1 Ω
E51-6 (EFIO) - A12-11 (IMI)
E51-5 (EFII) or A12-10 (IMO) - Body ground
10 kΩ or higher
E51-6 (EFIO) or A12-11 (IMI) - Body ground
- for 2AD-FHV, 2AD-FTV:
Tester Connection
Specified Condition
E51-5 (EFII) - A12-15 (IMO)
Below 1 Ω
E51-6 (EFIO) - A12-16 (IMI)
E51-5 (EFII) or A12-15 (IMO) - Body ground
10 kΩ or higher
E51-6 (EFIO) or A12-16 (IMI) - Body ground
|
|
||||
| OK | |
| 3. REREGISTER ECU CODE REGISTRATION |
Clear the DTC.
Reregister the ID code box and ECM communication ID.
Check that the engine starts.
- OK:
- Engine starts.
|
|
||||
| NG | |
| 4. CHECK ID CODE BOX (OPERATION) |
Temporarily replace the ID code box with a new or normally functioning one.
Check that the engine starts.
- OK:
- Engine starts.
|
|
||||
| OK | ||
| ||
