2005-2008 RAV4 · Service Manual SECURITIES

B2799 Engine Immobiliser System Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the ID code box; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the ID code box and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no certification ECU DTCs are present. If present, troubleshoot the certification ECU DTCs first.
DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and ID code box
  2. Error in communication lines
  3. Communication ID is different during communication with ID code box
  1. Wire harness
  2. ID code box
  3. ECM

WIRING DIAGRAM

B121684E09

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Delete the DTC (Click here).

  1. Recheck for the DTC.

    OK:
    B2799 output does not reoccur.



OK
NORMAL
NG


2. CHECK WIRE HARNESS (ID CODE BOX - ECM)
B130921E02
  1. Disconnect the E51 box connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness connectors.

    Standard resistance:
    for 1AZ-FE, 2AZ-FE:
    Tester Connection
    Specified Condition
    E51-5 (EFII) - A12-10 (IMO)
    Below 1 Ω
    E51-6 (EFIO) - A12-11 (IMI)
    E51-5 (EFII) or A12-10 (IMO) - Body ground
    10 kΩ or higher
    E51-6 (EFIO) or A12-11 (IMI) - Body ground
    for 2AD-FHV, 2AD-FTV:
    Tester Connection
    Specified Condition
    E51-5 (EFII) - A12-15 (IMO)
    Below 1 Ω
    E51-6 (EFIO) - A12-16 (IMI)
    E51-5 (EFII) or A12-15 (IMO) - Body ground
    10 kΩ or higher
    E51-6 (EFIO) or A12-16 (IMI) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. REREGISTER ECU CODE REGISTRATION
  1. Clear the DTC.

  1. Reregister the ID code box and ECM communication ID.

  1. Check that the engine starts.

    OK:
    Engine starts.



OK
END (PROBLEM HAS BEEN CAUSED BY REGISTRATION FAILURE)
NG


4. CHECK ID CODE BOX (OPERATION)
  1. Temporarily replace the ID code box with a new or normally functioning one.

  1. Check that the engine starts.

    OK:
    Engine starts.



NG
REPLACE ECM
OK

END (ID CODE BOX IS DEFECTIVE)


← B2799 Engine Immobiliser System Malfunction (Nov 2005 – Dec 2006)ID Code Box Power Source Circuit (from Nov 2005) →