ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2007
| CHECK AIR FUEL RATIO COMPENSATION SYSTEM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the following menu items: Data List / AFS B1 S1, AFS B2 S1, O2S B1 S2 and O2S B2 S2.
Warm up the A/F sensor with the engine speed at 2500 rpm for approximately 2 minutes.
Maintain the engine speed at 2500 rpm and confirm that the displays of "AFS B1 S1" and "AFS B2 S1" are as shown in the illustration.

- HINT:
- The illustration may slightly differ from the display on the intelligent tester.
- Only the intelligent tester displays the waveform of the A/F sensor.
- The illustration may slightly differ from the display on the intelligent tester.
Confirm that the displays of "O2S B1 S2" and "O2S B2 S2" change between 0 and 1 V with the engine speed at 2500 rpm.
- OK:
- The voltage output oscillates more than 8 times in 10 seconds.
- NOTICE:
- Perform the check immediately after warming the engine up.
- If the voltage output does not oscillate as specified, warm up the A/F sensor again. If the output is not as specified even after warming up the sensor again, check for DTCs (Click here).
- Perform the check immediately after warming the engine up.
