2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. REMOVE AIR FUEL RATIO SENSOR (for Bank 2)
  1. Disconnect the air fuel ratio sensor connector.

  1. A173720E01
    Using SST, remove the air fuel ratio sensor (for bank 2) from the exhaust manifold.
    SST
    09224-00010  


2. REMOVE NO. 2 EXHAUST PIPE SUB-ASSEMBLY (for Bank 1)
  1. Remove the 2 bolts and 2 nuts.

  1. Remove the No. 2 exhaust pipe sub-assembly from the 3 exhaust pipe supports.

  1. Remove the gasket.

    A173724


3. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for Bank 1)

  1. Remove the 2 bolts, 2 nuts, and center exhaust pipe assembly.

    A173725

  1. Remove the 2 gaskets.


4. REMOVE NO. 1 FRONT EXHAUST PIPE SUPPORT BRACKET (for Bank 1)
  1. Remove the 2 bolts and No. 1 exhaust pipe support bracket.


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Bank 1)
  1. Remove the 2 bolts and No. 1 exhaust pipe support bracket.


6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Bank 1)
(Click here)

7. REMOVE MANIFOLD STAY (for Bank 1)

  1. A171613
    Remove the 2 bolts, nut and manifold stay.


8. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH (for Bank 1)
  1. Disconnect the air fuel ratio sensor connector clamp.

  1. A133291
    Uniformly loosen and remove the 6 nuts.

  1. Remove the manifold and gasket.


9. REMOVE AIR FUEL RATIO SENSOR (for Bank 1)

  1. A173784E01
    Using SST, remove the air fuel ratio sensor (for bank 1).
    SST
    09224-00010  

← ON-VEHICLE INSPECTION (from Aug 2007)INSPECTION (from Aug 2007) →