2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

NOTICE:
  1. DTCs for the CAN communication system are as follows: U0073, U0100, U0105, U0121, U0122, U0123, U0124, U0126, U0129, C1280, C1296, C1297, B1207*, B2326* and B1499. (*: w/ Entry and start system)
  2. Refer to the troubleshooting procedures of each system if DTCs regarding the CAN communication system are not output.
  3. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  4. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  5. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  6. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. *: Use the intelligent tester (with CAN VIM).
  2. Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK CAN BUS LINE

      HINT:
      1. The Check CAN bus line (LHD Models) (Click here).
      2. The Check CAN bus line (RHD Models) (Click here).

    NEXT

    4.CHECK INSTALLED SYSTEMS (ECU AND SENSOR) THAT USE CAN COMMUNICATION
      NEXT

      5.CHECK AND CLEAR DTC*
        NEXT

        6.CHECK INTELLIGENT TESTER VIA CAN VIM*
        1. Select "Communication Bus Check" (Click here).

          Result 
          Result
          Proceed to
          All ECUs and sensors connected to CAN communication system displayed on screen.
          A
          One ECU or sensor connected to CAN communication system not displayed on screen.
          B
          2 or more ECU and sensors connected to CAN communication system not displayed on screen.
          C

        2. NOTICE:
          1. The systems (ECUs and sensors) that use CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs and sensors) are installed on the vehicle (Click here).
          2. Non-installed ECUs or sensors are not displayed. Do not mistake them for being in communication stop mode.
          3. If 2 or more ECUs or sensors are not displayed on the intelligent tester, perform troubleshooting for open circuits in one side of the CAN branch line for each undisplayed ECU or sensor.


        B.

        C.
        A

        7.DTC COMBINATION TABLE
        1. Confirm the trouble according to the combination of output DTCs regarding the CAN communication system.

        2. HINT:
          Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester "Communication Bus Check" screen.

        3. Check the DTC combination table (Click here).

        NEXT

        8.CIRCUIT INSPECTION
          NEXT

          9.IDENTIFY PROBLEM
            NEXT

            10.REPAIR OR REPLACE
              NEXT

              11.CONFIRMATION TEST
                NEXT

                ← HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2005 – Jul 2008)PROBLEM SYMPTOMS TABLE (from Nov 2005) →