2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Steering Angle Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

DESCRIPTION

Detection Item
Symptom
Trouble Area
STEERING ANGLE SENSOR COMMUNICATION STOP MODE
  1. Steering Angle Sensor is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "STEERING ANGLE SENSOR COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside steering angle sensor
  2. Steering angle sensor branch wire and connector
  3. Steering angle sensor

HINT:
For 2WD with VSC and 4WD only.


WIRING DIAGRAM

C129192E12

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (STEERING ANGLE SENSOR BRANCH WIRE)
F100892E12
  1. Disconnect the E14 steering angle sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E14-10 (CANH) - E14-9 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE BRANCH WIRE CONNECTED TO STEERING ANGLE SENSOR (CANH, CANL)
OK


2. CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BATTERY AND BODY GROUND)

  1. F100892E13
    Disconnect the E14 steering angle sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E14-2 (ESS) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E14-3 (BAT) - Body ground
    Always
    10 to 14 V
    E14-1 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE STEERING ANGLE SENSOR


← Power Steering ECU Communication Stop Mode (from Nov 2005)Steering Angle Sensor Communication Stop Mode (from Aug 2008) →