2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Power Steering ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
POWER STEERING ECU COMMUNICATION STOP MODE
  1. EPS is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "POWER STEERING ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside power steering ECU
  2. Power steering ECU branch wire and connector
  3. Power steering ECU

WIRING DIAGRAM

C129194E03

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (POWER STEERING ECU BRANCH WIRE)

  1. C128052E04
    Disconnect the E21 power steering ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-2 (CANH) - E21-8 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO POWER STEERING ECU (CANH, CANL)
OK


2. CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY AND BODY GROUND)

  1. C128054E02
    Disconnect the A2 and E21 power steering ECU connectors.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A2-2 (PGND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connectors.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A2-1 (PIG) - Body ground
    Always
    10 to 14 V
    E21-5 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER STEERING ECU


← Air Conditioning Amplifier Communication Stop Mode (from Nov 2005)Steering Angle Sensor Communication Stop Mode (Nov 2005 – Jul 2008) →