2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Yaw Rate Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

DESCRIPTION

Detection Item
Symptom
Trouble Area
YAW RATE SENSOR COMMUNICATION STOP MODE
  1. Yaw Rate / Deceleration Sensor is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "YAW RATE SENSOR COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside yaw rate sensor
  2. Yaw rate sensor branch wire and connector
  3. Yaw rate sensor

HINT:
For vehicle with VSC only.


WIRING DIAGRAM

C129195E04

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (YAW RATE SENSOR BRANCH WIRE)
F100900E05
  1. Disconnect the K6 yaw rate sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K6-3 (CANH) - K6-2 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO YAW RATE SENSOR (CANH, CANL)
OK


2. CHECK WIRE HARNESS (YAW RATE SENSOR - BATTERY AND BODY GROUND)

  1. F100900E04
    Disconnect the K6 yaw rate sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    K6-1 (GND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    K6-5 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE YAW RATE SENSOR


← Steering Angle Sensor Communication Stop Mode (from Aug 2008)Yaw Rate Sensor Communication Stop Mode (from Aug 2008) →