2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

4WD Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
4WD CONTROL ECU COMMUNICATION STOP MODE
  1. Four Wheel Drive Control is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "4WD CONTROL ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside 4WD control ECU
  2. 4WD control ECU branch wire and connector
  3. 4WD control ECU

HINT:
For vehicle with 4WD only.


WIRING DIAGRAM

C129192E13

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (4WD CONTROL ECU BRANCH WIRE)

  1. C128520E01
    Disconnect the E67 4WD control ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E67-14 (CANH) - E67-16 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO 4WD CONTROL ECU (CANH, CANL)
OK


2. CHECK WIRE HARNESS (4WD CONTROL ECU - BATTERY AND BODY GROUND)

  1. C128520E02
    Disconnect the E67 4WD control ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E67-23 (GND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E67-9 (BSLC) - Body ground
    Always
    10 to 14 V
    E67-11 (IG1) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE 4WD CONTROL ECU


← Center Airbag Sensor Communication Stop Mode (from Nov 2005)Check CAN Bus Line (LHD Models) (Nov 2005 – Jul 2008) →