2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

Center Airbag Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
CENTER AIRBAG SENSOR COMMUNICATION STOP MODE
  1. SRS Airbag is not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "CENTER AIRBAG SENSOR COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside center airbag sensor assembly
  2. Center airbag sensor assembly branch wire and connector
  3. Center airbag sensor assembly

WIRING DIAGRAM

C129196E05

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the main wire and the branch wire.
  2. For Auto:
    After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. For Reminder:
    After the ignition switch is turned off, check that the key reminder warning system and light reminder buzzer are not in operation.
  4. Before measuring the resistance, leave the vehicle for at least 1 minute and do not operate the ignition switch, any switches or doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)

  1. B117467E05
    Disconnect the E49 center airbag sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E49-13 (CANH) - E49-22 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE AND CONNECTOR (CANH, CANL)
OK


2. CHECK WIRE HARNESS (CENTER AIRBAG SENSOR ASSEMBLY - BATTERY AND BODY GROUND)
B117467E06
  1. Disconnect the E49 center airbag sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E49-25 (E1) - Body ground
    Below 1 Ω
    E49-26 (E2) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E49-21 (IG2) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY


← Combination Meter ECU Communication Stop Mode (from Nov 2005)4WD Control ECU Communication Stop Mode (from Nov 2005) →