C1267/67 Brake Pedal Load Sensing Switch
Diagnostic trouble codes · Vehicles built Aug 2007 – Jul 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008
DESCRIPTION
The brake pedal load sensing switch is turned on when the brake pedal is depressed with force exceeding a predetermined level.The skid control ECU detects if the brake pedal is depressed or not via this circuit.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1267/67 |
When one of following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
- HINT:
- If C1249/49 is output, repair it before repairing C1267/67 based on the flow chart below.
| 1. READ VALUE USING INTELLIGENT TESTER (BRAKE PEDAL LOAD SENSING SWITCH) |
Check the Data List for proper functioning of the brake pedal load sensing switch.
Skid control ECU Item (Display)
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
Brake Pedal Load Sensing SW
Brake pedal load sensing switch / ON or OFF
ON: Depressed brake pedal
OFF: Released brake pedal
-
- OK:
- ON (brake pedal is depressed) appears on the screen.
|
|
||||
| NG | |
| 2. INSPECT BRAKE PEDAL LOAD SENSING SWITCH |




- NOTICE:
- Do not remove the brake pedal load sensing switch from the brake pedal.
- When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal.
- Do not remove the brake pedal load sensing switch from the brake pedal.
Turn the ignition switch off.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
2 - 1
Brake pedal depressed (OFF)
0.95 to 1.05 kΩ
2 - 1
Brake pedal released (ON)
202.4 to 223.7 Ω
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH) |
Disconnect the A26 ECU connector.

Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
A26-7 (FSW+) - A3-2
Below 1 Ω
A26-7 (FSW+) - Body ground
10 kΩ or higher
A3-1 - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is recorded (Click here).
Result Result
Proceed to
DTC (C1267/67) is not output
A
DTC (C1267/67) is output
B
|
|
||||
| A | ||
| ||
