REPLACEMENT
Removal / installation · Vehicles built from Aug 2007
| 1.
REPLACE TIMING CHAIN COVER OIL SEAL |
 |
- Using a screwdriver, pry out the oil seal.
- HINT:
- Tape the screwdriver tip before use.
- NOTICE:
- Do not damage the surface of the oil seal press fit hole.
- Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing chain cover edge.
- SST
- 09316-60011
(09316-00011)
- NOTICE:
- Keep the lip free from foreign matter.
- Do not tap the oil seal at an angle.
- Make sure that the oil seal edge does not stick out of the timing chain case.
Apply MP grease to the lip of the oil seal.