2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. INSTALL ECM

  1. A124573
    Install the 2 ECM brackets with the 4 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }

  1. A124572
    Connect the 2 ECM connectors.

    1. Connect the 2 connectors to the ECM and lower the 2 levers.

      NOTICE:
      Make sure that the 2 levers are securely lowered.

  1. A124570
    Install the ECM with the 3 bolts.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }


2. INSTALL AIR CLEANER CASE

  1. A124928E01
    Install the cleaner case with the 3 bolts and connect the wire harness clamp.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the air filter element.


3. INSTALL AIR CLEANER CAP

  1. A124929E01
    Insert the hinge parts of the air cleaner cap into the air cleaner case, and then hang the 3 hook clamps.

  1. Connect the mass air flow meter connector.

  1. Engage the wire harness clamp.


4. INSTALL NO. 1 ENGINE COVER

  1. A123518
    Attach the 4 clips to install the engine cover.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM REGISTRATION
  1. When the ECM is replacing, all of the existing injector compensation codes and transfer catalyst record of DPNR must be input into the new ECM (Click here).

  1. w/ cruise control
    When replacing the ECM, perform vehicle stability control system recognition in ECM (Click here).


7. INITIALIZE THE LEARNING VALUE OF THE SUPPLY PUMP ASSEMBLY
  1. Perform initialization procedure (Click here)

← INSTALLATION (Nov 2005 – Dec 2006)COMPONENTS (from Nov 2005) →