REMOVAL
Removal / installation · Vehicles built from Aug 2007
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE BATTERY CLAMP SUB-ASSEMBLY |
Remove the bolt and loosen the nut.

Detach the 2 wire harness clamps.
Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.
| 3. REMOVE BATTERY |
| 4. REMOVE FRONT BATTERY BRACKET |
Detach the 2 wire harness clamps.

Remove the 4 bolts and front bracket.
| 5. REMOVE BATTERY BRACKET REINFORCEMENT |
Remove the 2 bolts and bracket reinforcement.

| 6. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the switch connector from the park/neutral position switch assembly.

Remove the nut and disconnect the control cable from the control shaft lever.

Remove the nut, washer and control shaft lever.

Using a screwdriver, pry out the lock plate.

Remove the nut and lock plate.
Remove the 2 bolts and pull out the park/neutral position switch assembly.

