INSTALLATION
Removal / installation · Vehicles built from Aug 2007
| 1. INSTALL TRANSMISSION WIRE |
Coat a new O-ring of the transmission wire connector with ATF.

Install the O-ring to the transmission wire connector.
Install the transmission wire.

Install the bolt.
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
Connect the connector.
Coat the O-ring of the ATF temperature sensor with ATF.

Apply ATF to the bolt.
Install the ATF temperature sensor with the lock plate and bolt.
- Torque:
- 6.6 N*m{ 67 kgf*cm , 58 in.*lbf }
Connect the 7 shift solenoid valve connectors.
| 2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() ![]() |
Install the 2 magnets in the oil pan.
Apply adhesive to the 18 bolts.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Install a new gasket and the oil pan with the 18 bolts.

- Torque:
- 7.6 N*m{ 77 kgf*cm , 67 in.*lbf }
| 3. INSTALL NO. 1 ENGINE UNDER COVER |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. ADD AUTOMATIC TRANSAXLE FLUID |
- Fluid type:
- Toyota Genuine ATF WS
| 6. INSPECT TRANSAXLE FLUID LEVEL |
Inspect the fluid level (Click here).

