2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

C133987
  1. Install the park/neutral position switch assembly to the manual valve shaft.

  1. Temporarily install the 2 bolts.

  1. C133988
    Install a new lock plate and the manual valve shaft nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }

  1. Temporarily install the control shaft lever.

  1. C133989E01
    Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.

  1. Remove the control shaft lever.

  1. C133990E01
    Align the groove and neutral basic line.

  1. Hold the park/neutral position switch assembly in this position and tighten the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. C133986
    Using a screwdriver, stake the nut with the lock washer.

  1. C133985
    Install the control shaft lever with the washer and nut.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Connect the shift control cable to the control shaft lever with the nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Connect the connector to the park/neutral position switch assembly.


2. INSTALL BATTERY BRACKET REINFORCEMENT

  1. A124919
    Install the bracket reinforcement with the 2 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }


3. INSTALL FRONT BATTERY BRACKET

  1. A173727
    Install the front battery bracket with the 4 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. Attach the 2 wire harness clamps.


4. INSTALL BATTERY

5. INSTALL BATTERY CLAMP SUB-ASSEMBLY
  1. Attach the hook of the battery clamp to the front battery bracket.

  1. Temporarily tighten the nut and install the bolt.

  1. Adjust the battery clamp position.

  1. A124917E01
    Fully tighten the nut and bolt.

    Torque:
    Bolt:
    17 N*m{ 170 kgf*cm , 12 ft.*lbf }
    Nut:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Attach the 2 wire harness clamps.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. ADJUST SHIFT LEVER POSITION
  1. Adjust the shift lever position (Click here).


8. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Inspect the switch (Click here).

← ADJUSTMENT (from Aug 2007)COMPONENTS (from Aug 2007) →