2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

  1. C050017E01
    Install the check ball body spring and check ball body.

  1. C091933E08
    Align the groove of the manual valve with the pin of the manual valve lever.

  1. Apply ATF to the 17 bolts.

  1. Install the 17 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    NOTICE:
    1. Push the valve body against the accumulator piston spring and the check ball body to install it.
    2. Temporarily tighten the bolts marked by * in the illustration first because they are positioning bolts.

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    Bolt A:
    25 mm (0.984 in.)
    Bolt B:
    57 mm (2.244 in.)
    Bolt C:
    41 mm (1.614 in.)


2. CONNECT TRANSMISSION WIRE

C091927E11
  1. Coat the O-ring with ATF.

  1. Apply ATF to the bolt.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf }

  1. Connect the 7 shift solenoid valve connectors.


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

C069150E01
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the oil strainer.

  1. Apply ATF to the 3 bolts.

  1. C091931E02
    Install the oil strainer with the 3 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }


4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C086316E02
  1. Install the 2 magnets in the oil pan.

  1. Apply adhesive to the 18 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. C091925E01
    Install a new gasket and the oil pan with the 18 bolts.

    Torque:
    7.6 N*m{ 77 kgf*cm , 67 in.*lbf }


5. INSTALL NO. 1 ENGINE UNDER COVER

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
Toyota Genuine ATF WS


8. INSPECT TRANSAXLE FLUID LEVEL
  1. Inspect the fluid level (Click here).


9. PERFORM RESET MEMORY
  1. Perform the RESET MEMORY procedures (A/T initialization) (Click here).

← REMOVAL (from Aug 2007)PARTS LOCATION (from Aug 2007) →