2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER

3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }


4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C083111E01
  1. Remove the 18 bolts, oil pan and gasket.

    NOTICE:
    Some fluid will remain in the oil pan. Carefully remove the oil pan sub-assembly.

  1. Remove the 2 magnets from the oil pan.

  1. AT00103E01
    Examine the particles in the pan.

    1. Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to see the type of wear which might be found in the transaxle.
      Steel (magnetic): bearing, gear and plate wear
      Brass (non-magnetic): bushing wear


5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

C091931E02
  1. Remove the 3 bolts and oil strainer.

    NOTICE:
    Perform the operation carefully as some fluid will come out from the oil strainer.

  1. C069150E01
    Remove the O-ring from the oil strainer.


6. DISCONNECT TRANSMISSION WIRE

  1. C091927E11
    Disconnect the 7 connectors.

  1. Remove the bolt and lock plate, and remove the ATF temperature sensor.


7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

C091933E07
  1. Support the valve body and remove the 17 bolts and valve body.

    NOTICE:
    Do not drop the check ball body, check ball body spring or accumulator piston.

  1. C050017E01
    Remove the check ball body and check ball body spring.

← COMPONENTS (from Aug 2007)INSTALLATION (from Aug 2007) →