REASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1.
INSTALL FRONT OIL PUMP OIL SEAL |
 |
Using SST and a hammer, install a new oil seal to the pump.
- SST
- 09350-32014
(09351-32140)
- HINT:
- The seal end should be flat with the outer edge of the oil pump.
Coat the lip of the oil seal with petroleum jelly.
| 2.
INSTALL FRONT OIL PUMP BODY O-RING |
 |
Coat the new O-ring with ATF, and install it to the oil pump body.
| 3.
INSTALL FRONT OIL PUMP DRIVEN GEAR |
 |
Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing up.
| 4.
INSTALL FRONT OIL PUMP DRIVE GEAR |
 |
Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing up.
| 5.
INSTALL STATOR SHAFT ASSEMBLY |
 |
Set the stator shaft by aligning each bolt hole.
Using a T30 ''trox'' socket, install the 11 bolts.
-
Torque:
- 9.8 N*m{
100 kgf*cm
, 87 in.*lbf
}
| 6.
INSTALL CLUTCH DRUM OIL SEAL RING |
 |
Install the 2 clutch drum oil seal rings.
- NOTICE:
- Do not expand the ring ends excessively.
| 7.
INSPECT OIL PUMP ASSEMBLY
|
 |
Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.
- NOTICE:
- Be careful not to damage the oil seal lip.