DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. INSPECT FORWARD CLUTCH |
![]() ![]() |
Install the forward clutch on the oil pump.
- NOTICE:
- Be careful not to damage the oil seal ring of oil pump.
Using a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi)
- Standard position stroke:
- 1.74 to 2.08 mm (0.0685 to 0.0819 in.)
If the clearance is not as specified, select another flange.- HINT:
- As the opening is big, cover it with a shop rag to prevent the compressed air from being discharged.
| 2. REMOVE FORWARD MULTIPLE DISC CLUTCH DISC |
![]() ![]() |
Using a screwdriver, remove the snap ring.
Remove the flange , 5 discs and 5 plates from the input shaft.

| 3. INSPECT FORWARD MULTIPLE DISC CLUTCH DISC |
![]() ![]() |
Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
If necessary, replace them.- HINT:
- If the lining of the disc is peeling off or discolored, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of the disc is peeling off or discolored, replace all discs.
| 4. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() ![]() |
Place SST on the spring retainer and compress the return spring with a press.
- SST
- 09350-32014
(09351-32070)
Using a snap ring expander, remove the snap ring.
Remove the piston return spring.

| 5. INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() ![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
- Standard free length:
- 28.23 mm (1.1102 in.)
| 6. REMOVE FORWARD CLUTCH PISTON SUB-ASSEMBLY |
![]() ![]() |
Place the forward clutch drum onto the oil pump.
Holding the forward clutch piston with your hand, apply compressed air (392 kPa, 4.0kgf/cm2, 57 psi) to the oil pump to remove the forward clutch piston.
- HINT:
- When the piston is slanted and cannot be removed, remove it by pushing down the protruding side and applying compressed air again, or using needle-nose pliers (with its tips wrapped in tape).
Using a screwdriver, pry out the 2 O-rings.

| 7. REMOVE FORWARD CLUTCH PISTON SUB-ASSEMBLY |
![]() ![]() |
Shake the piston to check that the check ball is not stuck.
Check that air does not leak from the valve when applying low compressed air (392 kPa, 4.0 kgf*cm2, 57 psi)

| 8. REMOVE INPUT SHAFT OIL SEAL RING |
![]() ![]() |








