INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT PACK CLEARANCE OF FORWARD CLUTCH |
![]() ![]() |
Install the forward clutch on the oil pump.
- NOTICE:
- Be careful not to damage the oil seal ring of oil pump.
Using a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi)
- Standard position stroke:
- 1.74 to 2.08 mm (0.0685 to 0.0819 in.)
If the clearance is not as specified, select another flange.- HINT:
- As the opening is big, cover it with a shop rag to prevent the compressed air from being discharged.
| INSPECT FORWARD MULTIPLE DISC CLUTCH DISC |
![]() ![]() |
Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
If necessary, replace them.- HINT:
- If the lining of the disc is peeling off or discolored, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of the disc is peeling off or discolored, replace all discs.
| INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() ![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
- Standard free length:
- 28.23 mm (1.1102 in.)
| INSPECT FORWARD CLUTCH PISTON SUB-ASSEMBLY |
![]() ![]() |
Shake the piston to check that the check ball is not stuck.
Check that air does not leak from the valve when applying low compressed air (392 kPa, 4.0 kgf*cm2, 57 psi)





