REASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL INPUT SHAFT OIL SEAL RING |
![]() ![]() |
Compress the oil seal ring from both sides to reduce dimension A.
- Standard dimension A:
- 5 mm (0.197 in.)
Coat the oil seal ring with ATF and install it to the input shaft.
| 2. INSTALL FORWARD CLUTCH PISTON SUB-ASSEMBLY |
![]() ![]() |
Coat 2 new O-rings with ATF, and install them to the forward clutch piston.
Install the forward clutch piston to the forward clutch drum.

| 3. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() ![]() |
Place the return spring onto the piston.
- SST
- 09350-32014
(09351-32070)
Place SST on the return spring, and compress the return spring with a press.

Install the snap ring with a snap ring expander. Be sure the end gap of the snap ring is not aligned with the spring retainer claw.
- NOTICE:
- Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
- This prevents the spring sheet from being deformed.
- Do not expand the snap ring excessively.
- Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
Set the end gap of the snap ring in the piston shown in the illustration.

- NOTICE:
- The end gap of the snap ring should not coincide with any of the stoppers.
| 4. INSTALL FORWARD MULTIPLE DISC CLUTCH DISC |
![]() ![]() |
Install the 5 plates, 5 discs and flange.
- Install in order:
- P - D - P - D - P - D - P - D - P - D - F
- HINT:
- P = Plate
- D = Disc
- F = Flange
Using a screwdriver, install the snap ring.

Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 5. INSPECT PACK CLEARANCE OF FORWARD CLUTCH |
![]() ![]() |
Install the forward clutch on the oil pump.
- NOTICE:
- Be careful not to damage the oil seal ring of the oil pump.
Using a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kgf/cm2, 4.0 kPa, 57 psi)
- Standard piston stroke:
- 1.74 to 2.08 mm (0.0685 to 0.0819 in.)
- NOTICE:
- There are 5 different flanges in thickness.
- Standard flange thickness:
No.
Thickness
No.
Thickness
1
3.00 mm (0.1181 in.)
4
3.45 mm (0.1358 in.)
2
3.15 mm (0.1240 in.)
5
3.60 mm (0.1417 in.)
3
3.30 mm (0.1299 in.)
-
-
| 6. INSPECT FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC |
![]() ![]() |
Inspect the clutch disc rotation.
After inserting the multiple disc clutch into the multiple disc clutch hub, rotate the forward clutch and check that the disc lightly rotates.
- NOTICE:
- Do not place the forward clutch in a vise.






