If the power steering ECU detects a malfunction, the P/S warning light comes on. At this time, the power steering ECU stores a DTC in its memory.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When the power source voltage to the power steering ECU (terminals IG and PIG) drops, required steering effort increases and the P/S warning light turns on.
1. CHECK DTC
Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system.
OK:
CAN DTCs are not output.
NG
GO TO CAN COMMUNICATION SYSTEM
OK
2. READ VALUE USING INTELLIGENT TESTER (IG POWER SUPPLY)
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and press the intelligent tester main switch ON.
Select the item "IG power supply" in the Data List and read the value displayed on the intelligent tester.
Power steering ECU:
Item
Item Description: Range (Display)
Inspection Condition
Specified Condition
IG Power Supply
ECU power source voltage: Min.: 0 V Max.: 20.1531 V
Ignition switch on (IG)
10 to 14 V
OK:
The normal condition value is displayed on the intelligent tester.