DATA LIST / ACTIVE TEST
System information · Vehicles built from Nov 2005
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values of states of switches, sensors, actuators and other items to be read without removing any parts. This non-instrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and press the intelligent tester main switch ON.
Read the Data List by following the directions on the tester screen.
Certification ECUĀ Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Sensor Value
Sensor malfunction /
NG (Past) or OK
NG (Past): Sensor malfunction
OK: No malfunction
-
Power Supply Short
Short in ECU /
NG (Past) or OK
NG (Past): Short in ECU
OK: No malfunction
-
Power Supply Open
Open in ECU /
NG (Past) or OK
NG (Past): Open in ECU
OK: No malfunction
-
Motor Driver Short
Short in driver ECU /
NG (Past) or OK
NG (Past): Short in driver ECU
OK: No malfunction
-
Motor Driver Open
Open in driver ECU /
NG (Past) or OK
NG (Past): Open in driver ECU
OK: No malfunction
-
Lock / Unlock Receive
Steering lock command reception record /
YES or NO
YES: Steering lock / unlock signal received
NO: Steering lock / unlock signal not received
-
Lock Bar Stuck Error
Lock bar stuck malfunction /
NG (Past) or OK
NG (Past): Lock bar stuck malfunction
OK: No malfunction
-
Push Start Error
Push button start function malfunction /
NG (Past) or OK
NG (Past): Malfunction in push button start
OK: No malfunction
-
IG2 Status
IG2 voltage /
ON or OFF
ON: 10 to 14 V
OFF: Below 1 V
-
IG (Lin)
LIN bus start-up status /
ON or OFF
ON: LIN bus started-up
OFF: LIN bus not started-up
-
S Code Check
S code match record /
NG or OK
NG: S code not matched
OK: S code matched
-
L Code Check
L code match record /
NG or OK
NG: L code not matched
OK: L code matched
-
Unlock Request Receive
Steering lock unlock command reception status
NG or OK
NG: Unlock request not received
OK: Unlock request received
-
Lock Request Receive
Steering lock lock command reception status
NG or OK
NG: Lock request not received
OK: Lock request received
-
S Code Check (Past)
S code match record /
NG (Past) or OK
NG (Past): S code not matched
OK: S code matched
-
L Code Check (Past)
L code match record /
NG (Past) or OK
NG (Past): L code not matched
OK: L code matched
-