B2785 Communication Malfunction between ECUs Connected by LIN
Diagnostic trouble codes · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
This DTC is output when the communication among the certification ECU, instrument panel junction block (main body ECU), ID code box and steering lock actuator (steering lock ECU) stops for 10 seconds or more.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2785 |
LIN communication from certification ECU stops for specified amount of time |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for the DTC.
- OK:
- B2785 output does not reoccur.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (LIN COMMUNICATION LINE) |


Disconnect the E6 and E63 ECU connectors.
Disconnect the E51 box connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E63-10 (LIN) - E51-3 (LIN1)
Below 1 Ω
E63-10 (LIN) - ID-9 (LIN1)
E63-10 (LIN) - E6-5 (LIN)
E63-10 (LIN), E51-3 (LIN1), ID-9 (LIN1) or E6-5 (LIN) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK CERTIFICATION ECU (OPERATION) |
Temporarily replace the certification ECU with a new or normally functioning one.
Check for a DTC.
- OK:
- B2785 output does not reoccur.
|
|
||||
| NG | |
| 4. CHECK INSTRUMENT PANEL JUNCTION BLOCK (OPERATION) |
Temporarily replacing the instrument panel junction block (main body ECU) with a new or normally functioning one.
Check for a DTC.
- OK:
- B2785 output does not reoccur.
|
|
||||
| NG | |
| 5. CHECK STEERING LOCK ACTUATOR ASSEMBLY (OPERATION) |
Temporarily replace the steering lock actuator (steering lock ECU) with a new or normally functioning one.
Check for a DTC.
- OK:
- B2785 output does not reoccur.
|
|
||||
| NG | ||
| ||
