2005-2008 RAV4 · Service Manual SECURITIES

ID Code Box Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit provides power to operate the ID code box.

WIRING DIAGRAM

B130972E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room No. 2 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (ID CODE BOX - BATTERY AND BODY GROUND)
B107455E12
  1. Disconnect the E51 box connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E51-8 (GND) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Specified Condition
    E51-1 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← B2799 Engine Immobiliser System Malfunction (from Jan 2007)Certification ECU Power Source Circuit (from Nov 2005) →