2005-2008 RAV4 · Service Manual SECURITIES

B2780 Push Switch / Key Unlock Warning Switch Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

This DTC is output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is on (IG). Under normal conditions, the unlock warning switch is ON when the ignition switch is on (IG).
DTC No.
DTC Detection Condition
Trouble Area
B2780
Unlock warning switch ON is not detected when ignition switch is on (IG)
  1. Transponder key ECU
  2. Unlock warning switch
  3. Wire harness

WIRING DIAGRAM

B110397E06

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) with a key that cannot start the engine.

  1. On the intelligent tester, enter the following menus: Body / Engine Immobiliser / Data List / Key SW. Read the result.

    Transponder key ECU: 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal / ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (key is in ignition key cylinder) appears on the screen.



OK
REPLACE TRANSPONDER KEY ECU
NG


2. INSPECT UNLOCK WARNING SWITCH ASSEMBLY
B115726E01
  1. Remove the unlock warning switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK


3. CHECK WIRE HARNESS (UNLOCK WARNING SWITCH - BODY GROUND)
B115727E03
  1. Disconnect the E9 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E9-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK WIRE HARNESS (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU)
B115728E04
  1. Disconnect the E9 switch connector.

  1. Disconnect the E50 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E9-1 - E50-3 (KSW)
    Below 1 Ω
    E9-1 or E50-3 (KSW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2007)B2784 Antenna Coil Open / Short (from Nov 2005) →