B2784 Antenna Coil Open / Short
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The transponder key coil receives key code signals from the transponder chip in the key grip. The coil built into the transponder key amplifier amplifies the key code signals and outputs the signal to the transponder key ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2784 |
When transponder key coil is open or short |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (TRANSPONDER KEY COIL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) with a key that cannot start the engine.
On the intelligent tester, enter the following menus: Body / Engine Immobiliser / Data List / Antenna Coil Status. Read the result.
Transponder key ECU: Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Antenna Coil Status
Transponder key coil condition / NORMAL or FAIL
NORMAL: Transponder key coil is normal
FAIL: Transponder key coil is malfunctioning
-
- OK:
- NORMAL (Transponder key coil is normal) appears on the screen.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
![]() ![]() |
Disconnect the E50 ECU connector.
Disconnect the E8 amplifier connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E50-14 (VC5) - E8-1 (VC5)
Below 1 Ω
E50-15 (CODE) - E8-4 (CODE)
E50-4 (TXCT) - E8-5 (TXCT)
E50-5 (AGND) - E8-7 (AGND)
E50-14 (VC5) or E8-1 (VC5) - Body ground
10 kΩ or higher
E50-15 (CODE) or E8-4 (CODE) - Body ground
E50-4 (TXCT) or E8-5 (TXCT) - Body ground
E50-5 (AGND) or E8-7 (AGND) - Body ground
|
|
||||
| OK | ||
| ||

