2005-2008 RAV4 · Service Manual SECURITIES

B2799 Engine Immobiliser System Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.
DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and transponder key ECU
  2. Error in communication lines
  3. Communication ID is different during communication with transponder key ECU
  1. Wire harness
  2. Transponder key ECU
  3. ECM

WIRING DIAGRAM

B121684E04

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Delete the DTC (Click here).

  1. Recheck for DTC.

    OK:
    B2799 output does not reoccur.



OK
NORMAL
NG


2. CHECK WIRE HARNESS (TRANSPONDER KEY ECU - ECM)
B130978E04
  1. Disconnect the E50 ECU connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    for 1AZ-FE, 2AZ-FE, 2GR-FE:
    Tester Connection
    Specified Condition
    E50-13 (EFIO) - A12-11 (IMI)
    Below 1 Ω
    E50-12 (EFII) - A12-10 (IMO)
    E50-13 (EFIO) or A12-11 (IMI) - Body ground
    10 kΩ or higher
    E50-12 (EFII) or A12-10 (IMO) - Body ground
    for 2AD-FHV, 2AD-FTV:
    Tester Connection
    Specified Condition
    E50-13 (EFIO) - A12-16 (IMI)
    Below 1 Ω
    E50-12 (EFII) - A12-15 (IMO)
    E50-13 (EFIO) or A12-16 (IMI) - Body ground
    10 kΩ or higher
    E50-12 (EFII) or A12-15 (IMO) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. CHECK TRANSPONDER KEY ECU (OPERATION)
  1. Temporarily replace the transponder key ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
REPLACE ECM
OK

END (TRANSPONDER KEY ECU IS DEFECTIVE)


← B2799 Engine Immobiliser System Malfunction (Jan 2007 – Jul 2007)Security Indicator Light Circuit (from Nov 2005) →