Security Indicator Light Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
When the transponder key is registered, the transponder key ECU indicates the key registration condition by lighting up, blinking or turning off the security indicator.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT) |
Select the Active Test, use the intelligent tester (with CAN VIM) to generate a command, and then check that the security indicator light operation is normal.
Transponder key ECU: Item
Normal Condition
Diagnostic Note
Security Indic
Security indicator light turns ON / OFF
-
- OK:
- Security indicator light turns ON / OFF
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (TRANSPONDER KEY ECU AND BODY GROUND - SECURITY INDICATOR LIGHT) |


Disconnect the E50 ECU connector.
Disconnect the E25*1 or E26*2 light connector.
Measure the resistance of the wire harness side connectors.
- HINT:
- *1: for Manual air conditioning system
- *2: for Automatic air conditioning system
- Standard resistance:
- for Manual Air Conditioning System:
Tester Connection
Specified Condition
E50-8 (IND) - E25-8 (SEC)
Below 1 Ω
E25-5 (GND) - Body ground
E50-8 (IND) or E25-8 (SEC) - Body ground
10 kΩ or higher
- for Automatic Air Conditioning System:
Tester Connection
Specified Condition
E50-8 (IND) - E26-10 (LP)
Below 1 Ω
E26-7 (GND) - Body ground
E50-8 (IND) or E26-10 (LP) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT TRANSPONDER KEY ECU (OUTPUT) |
Remove the transponder key ECU with its connectors still connected.

Measure the voltage of the ECU.
- Standard voltage:
Tester Condition
Condition
Specified Condition
E50-8 (IND) - Body ground
Engine immobiliser system is set
10 to 14 V and below 1 V output alternately
|
|
||||
| OK | ||
| ||
