2005-2008 RAV4 · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
  1. Use these procedures to troubleshoot the theft deterrent system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTC.

    3. Recheck for DTCs. Based on the DTC output above, try to force output of the same DTC by simulating the symptoms indicated by the DTC.

      Result: 
      Result
      Proceed to
      DTC output does not reoccur
      A
      DTC output reoccurs
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)

    4. Inspection (Click here)

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2005)OPERATION CHECK (from Nov 2005) →