2005-2008 RAV4 · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit provides power to operate the theft warning ECU.

WIRING DIAGRAM

B129962E02

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room No. 2 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (THEFT WARNING ECU - BATTERY AND BODY GROUND)
B132525E01
  1. Disconnect the E83 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E83-16 (E) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Specified Condition
    E83-11(+B1) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU


← Security Indicator Light Circuit (from Nov 2005)INSPECTION (from Nov 2005) →