Security Indicator Light Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
When the theft deterrent system is in the disarmed state, the security indicator light will flash continuously if the engine immobiliser system is set, or not illuminate if the engine immobiliser system is not set.When the theft deterrent system is in the armed state, the engine immobiliser system is automatically set and the security indicator light will flash continuously.
When the theft deterrent system is in the arming preparation state and alarm sounding state, the theft warning ECU causes the security indicator light to illuminate.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR) |
Select the Active Test, use the intelligent tester to generate a command, and then check that the security indicator light operation is normal.
Theft warning ECU: Item
Test Details
Diagnostic Note
Security Indicator
Turns security indicator light ON / OFF
-
- OK:
- Turns security indicator light ON / OFF.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (THEFT WARNING ECU - SECURITY INDICATOR LIGHT) |


Disconnect the E83 ECU connector.
Disconnect the E22*1 or E23*2 light connector.
Measure the resistance of the wire harness side connectors.
- HINT:
- *1: for Manual air conditioning system
- *2: for Automatic air conditioning system
- Standard resistance:
- for Manual air conditioning system:
Tester Connection
Specified Condition
E83-29 (IND) - E22-8 (SEC)
Below 1 Ω
E22-5 (GND) - Body ground
E83-29 (IND) or E22-8 (SEC) - Body ground
10 kΩ or higher
- for Automatic air conditioning system:
Tester Connection
Specified Condition
E83-29 (IND) - E23-10 (LP)
Below 1 Ω
E23-7 (GND) - Body ground
E83-29 (IND) or E23-10 (LP) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT THEFT WARNING ECU (OUTPUT) |
![]() ![]() |
Reconnect the E83 ECU connector.
Disconnect the E22*1 or E23*2 light connector.
Measure the voltage of the ECU.
- HINT:
- *1: for Manual air conditioning system
- *2: for Automatic air conditioning system
- Standard voltage:
Tester Connection
Condition
Specified Condition
E83-29 (IND) - Body ground
Security indicator lights up (illuminates for 30 seconds in alarm sounding state and flashes when immobiliser system is operating)
5 V or more
|
|
||||
| OK | ||
| ||

