Engine Hood Courtesy Switch Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The engine hood courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (ENGINE HOOD COURTESY SWITCH) |
Check the Data List for proper functioning of the engine hood courtesy switch.
Theft warning ECU: Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Hood Courtesy SW
Hood courtesy switch / ON or OFF
ON: Engine hood is open
OFF: Engine hood is closed
-
- OK:
- On tester screen, item changes between ON and OFF according to above chart.
|
|
||||
| NG | |
| 2. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) |
![]() ![]() |
Disconnect the A60 switch connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Lock (OFF)
10 kΩ or higher
Unlock (ON)
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (THEFT WARNING ECU - ENGINE HOOD COURTESY SWITCH) |
![]() ![]() |
Disconnect the E83 ECU connector.
Disconnect the A60 switch connector.
Measure the resistance of the connectors.
- Standard resistance:
Tester Connection
Specified Condition
E83-4 (DSWH) - A60-2
Below 1 Ω
E83-4 (DSWH) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (HOOD COURTESY SWITCH - BODY GROUND) |
![]() ![]() |
Disconnect the A60 switch connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
A60-1 - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||



