2005-2008 RAV4 · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
  1. Use these procedures to troubleshoot the entry and start system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

    2. Result: 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B

    B.
    A

    4.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION
    1. Use the intelligent tester to check if the LIN communication system is functioning normally.

    2. Result: 
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B

    B.
    A

    5.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2005)OPERATION CHECK (from Nov 2005) →