Sliding Roof ECU Power Source Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.
| Item |
Test Details |
Diagnostic Note |
| Slide Roof |
Operate sliding roof OPEN / DOWN OPEN / DOWN: Sliding roof OPEN / DOWN operation occurs OFF: Sliding roof is not operating |
- |
| Slide Roof |
Operate sliding roof CLOSE / UP CLOSE / UP: Sliding roof CLOSE / UP operation occurs OFF: Sliding roof is not operating |
- |
- OK:
- Sliding roof operates normally.
|
|
||||
| OK | |
| 2. INSPECT FUSE (S/ROOF, ECU-IG1) |
Remove the S/ROOF and ECU-IG1 fuses from the instrument panel junction block.
Measure the resistance of the fuses.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - BODY GROUND) |
Disconnect the R9 drive gear connectors.

Measure the voltage and resistance of the wire harness side connectors.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
R9-1 (B) - Body ground
Always
10 to 14 V
R9-5 (IG) - Body ground
Ignition switch off
Below 1 V
R9-5 (IG) - Body ground
Ignition switch on (IG)
10 to 14 V
- Standard resistance:
Tester Connection
Specified Condition
R9-2 (E) - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||
