Sliding Roof Control Switch Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
If either the sliding function or tilt function does not operate, there may be a malfunction in the sliding roof control switch circuit.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.
Sliding roof ECU Item
Test Details
Diagnostic Note
Slide Roof
Operate sliding roof OPEN / DOWN
OPEN / DOWN: Sliding roof OPEN / DOWN operation occurs
OFF: Sliding roof is not operating
-
Slide Roof
Operate sliding roof CLOSE / UP
CLOSE / UP: Sliding roof CLOSE / UP operation occurs
OFF: Sliding roof is not operating
-
- OK:
- Sliding roof operates normally.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (SLIDING ROOF CONTROL SWITCH) |
Use the Data List to check if the sliding roof switch is functioning properly.
Sliding roof ECU Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Close Switch
Slide switch close signal / ON or OFF
ON: TILT UP switch is pressed
OFF: TILT UP switch is not pressed
-
Open Switch
Slide switch open signal / ON or OFF
ON: SLIDE OPEN switch is pressed
OFF: SLIDE OPEN switch is not pressed
-
- OK:
- When the switch is operating, the intelligent tester should display as shown in the table.
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS (OVERHEAD JUNCTION BLOCK - DRIVE GEAR AND BODY GROUND) |
Disconnect the R8 junction block connector.

Disconnect the R9 drive gear connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
R9-7 (DWN) - R8-9 (DOWN)
Below 1 Ω
R9-9 (UP) - R8-8 (UP)
Below 1 Ω
R8-7 (GND) - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||
