HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Nov 2005
- HINT:
- Use these procedures to troubleshoot the wiper and washer system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the wiper and washer system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester (with CAN VIM) to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
| |||||
| 6.REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
| |||||