2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Headlight Cleaner Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit detects the conditions of the headlight cleaner switch.

WIRING DIAGRAM

E124998E02

INSPECTION PROCEDURE


1. INSPECT HEADLIGHT CLEANER SWITCH
E125000
  1. Remove the headlight cleaner switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 - 8
    ON
    Below 25 Ω
    OFF
    10 kΩ or higher



NG
REPLACE HEADLIGHT CLEANER SWITCH
OK


2. CHECK WIRE HARNESS (SWITCH - ECU AND RELAY)
E125077E01
  1. Disconnect the E4 switch connector.

  1. Disconnect the A44 relay connector

  1. Disconnect the E18 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E4-8 - A44-2 (H)
    Below 1 Ω
    E4-5 - E18-20 (HRLY)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. CHECK WIRE HARNESS (RELAY - ECU)
E125078E01
  1. Disconnect the A44 relay connector

  1. Disconnect the E18 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A44-1 (HDLO) - E18-20 (HRLY)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Rain Sensor Circuit (from Nov 2005)Headlight Cleaner Motor and Relay Circuit (from Nov 2005) →